Heat pump
What is a heat pump?
A heat pump takes energy from a (relatively) low temperature source and raises it to a higher temperature to make it more useful. It is similar to a water pump, which raises water from a low level to another higher level; a heat pump does the same, but with heat.
Despite their name, heat pumps can heat and cool a space. They work by transferring heat rather than creating it. In cold weather, they pump heat from the outside of your home to the inside to warm the interior. An outdoor unit extracts the hot air and sends it through a refrigerant pipe connected to an indoor unit. The air is compressed along the way, which further warms it before it is blown into the house. In hot weather, the system does the opposite: it draws in warm air from inside and pumps it outside (which is also how a typical air conditioner works). A heat pump is capable of transporting more heat than the energy it consumes, so it can be considered very efficient.
It should be noted that a heat pump can provide heating, cooling and domestic hot water from a single unit, so it is useful all year round and maintenance is reduced to a single unit.
The great advantage of this system is that you only have one energy supply, so you do not have to pay charges for natural gas or butane, propane and diesel transport.
How does a heat pump work?
The principle of how heat pumps work is based on the principles of thermodynamics and can be structured into four steps:
– In the first step, the cooling fluid is at low temperature and low pressure and is therefore in a liquid state. The ambient air drawn in passes through the evaporator, where the refrigerant absorbs the heat from the ambient air and changes its state. At the same time, the air is expelled at a lower temperature.
– The cooling fluid arrives in step 2 as vapour but still at low pressure. Passing it through the compressor causes an increase in pressure and a consequent increase in temperature.
– This results in vapour in a high energy state (arising from the heat of the air in the evaporator plus the heat from the conversion of electrical energy into heat energy). This vapour obtained in step 3 circulates through the condenser located along the tank, where it transfers all the energy to the stored water, thus returning to the liquid state.
– In the last step of the process, the refrigerant fluid, already in a liquid state, is passed through the expansion valve to obtain the fluid in its initial conditions, i.e. at low pressure and low temperature. The process can then be restarted.
Types of heat pumps
There are three main types of heat pumps depending on the source:
– Air source: Aerothermal heat pumps, which are inexpensive to install and commonly used, work well in moderate climates, using outside air as the medium for the heat exchange.
– Water source: Water-source heat pumps dissipate heat by means of water instead of air. They require access to wells, lakes or other water sources, and are not as common.
– Ground source: Ground source heat pumps harness the thermal energy stored in the ground and transfer heat in a similar way to aerothermal heat pumps. Due to the constant ground temperature, they work much more efficiently, although their installation is more expensive and complicated due to the need to dig and install underground pipes.
The main subtypes are:
– Air-to-air: the heat taken from the air is transferred directly to the air in the room to be heated.
– Air-Water: heat is taken from the air and transferred to a water circuit that will supply floor/ceiling heating/cooling systems, low temperature radiators, fan convectors or fan heaters and Domestic Hot Water (DHW) storage tanks.
– Water-Water: the system takes heat from a water circuit in contact with an element that will provide it with heat (the ground, water table) to transfer it to another water circuit.
– Aerothermal systems : this type of equipment is capable of heating or cooling an environment, like air-to-air heat pumps, or of heating or cooling a radiant/cooling floor.